|
Derek Norfield, "Practical Balancing of Rotating Machinery"
English | 2006 | ISBN: 1856174654 | 218 pages | PDF | 3,6 MB
Rotating machinery (eg pumps, motors, compressors) is normally manufactured to precise measurements but there comes a point when the costs of manufacture mean that further precision is not cost-effective and thus any slight imbalance inherent in the machine will need to be attended to after manufacture. When such machinery is in operation, often at very high speeds of thousands of revs per minute, any imbalance will set up vibration and often noise. In addition, such imbalance will cause extra wear and loss of efficiency in the machine. The answer is to balance the affected parts of the machine so that it operates smoothly and efficiently.
This book is a practical account of such balancing techniques e.g how to balance a rotor, how to set up and verify performance of a balancing machine, and procedures for on-site balancing. In addition, other common causes of vibration will be covered e.g. misalignment, bad bearings and looseness.
| 
发表于 2013-3-10 07:00:18
